Notice: data is being updated, so some fields may be inaccurate.
Location
Australia, Victoria, Geelong
Correct Loading...
ASN History
Network
AS Organization
Country
First Seen
Last Seen
203.1.237.0/24
DataCenter AARNet
Australia
2017-01-01 08:38
2026-10-15 21:07
203.1.237.0/24
DataCenter Cenitex
Australia
2010-07-09 16:07
2012-01-30 08:40
203.1.237.0/24
DataCenter Deakin University
Australia
2004-01-21 21:28
2010-07-09 16:06
203.1.237.0/24
DataCenter Australian Academic and Research Network (AARNet)
Australia
2003-09-23 10:30
2007-04-20 11:38
203.1.237.0/24
DataCenter Vocus (PIPE/AAPT)
Australia
2001-10-29 02:47
2003-09-23 08:16
203.1.237.0/24
DataCenter WIDE Project
Japan
2002-04-29 23:37
2002-04-29 23:42
Organization registration history
Network
Registered since
Verified / ended
No verified organization registration records
The registered organization can differ from the ASN operator. Current records show the latest verification; past records show when they ended. Unknown start dates are shown as --.
Registration History
Registry
Country
First Seen
Last Seen
--
IP Location History
Location
Time
--
Recent queriesLatest 20 per type IP PING Traceroute DNS MTR HTTP Explore recently queried IP addresses.
Open IP→ Compare round-trip latency and packet loss from different locations.
Open PING→ History opens saved results. Select “Run again” to start a new test.
Inspect route paths, hop addresses and response times from different locations.
Open Traceroute→ History opens saved results. Select “Run again” to start a new test.
Compare DNS records, resolvers and response times across locations.
Open DNS→ History opens saved results. Select “Run again” to start a new test.
Combine route tracing with repeated probes to inspect hop latency and loss. Intermediate hop rate limiting does not establish destination packet loss.
Open MTR→ History opens saved results. Select “Run again” to start a new test.
Inspect HTTP status, response headers and request timings from different locations.
Open HTTP→ History opens saved results. Select “Run again” to start a new test.