Notice: data is being updated, so some fields may be inaccurate.
Location
Australia, Queensland, Herston
Correct Loading...
ASN History
Network
AS Organization
Country
First Seen
Last Seen
152.98.0.0/16
DataCenter AARNet
Australia
2018-01-01 20:18
2026-10-15 10:30
152.98.0.0/16
DataCenter Australian Academic and Research Network
Australia
2012-01-30 10:40
2017-04-12 20:00
152.98.0.0/16
DataCenter --
/ --
2005-08-11 22:19
2005-08-11 22:20
152.98.0.0/16
DataCenter GRid And Next GEneration NETwork
Australia
2005-07-04 05:53
2005-07-04 06:28
152.98.0.0/16
DataCenter The University of Queensland
Australia
2003-01-11 00:30
2005-04-13 13:12
152.98.0.0/16
ISP Availo Networks AB
Sweden
2002-04-10 02:11
2002-04-17 04:10
Organization registration history
Network
Registered since
Verified / ended
No verified organization registration records
The registered organization can differ from the ASN operator. Current records show the latest verification; past records show when they ended. Unknown start dates are shown as --.
Registration History
Registry
Country
First Seen
Last Seen
--
IP Location History
Location
Time
--
Recent queriesLatest 20 per type IP PING Traceroute DNS MTR HTTP Explore recently queried IP addresses.
Open IP→ Compare round-trip latency and packet loss from different locations.
Open PING→ History opens saved results. Select “Run again” to start a new test.
Inspect route paths, hop addresses and response times from different locations.
Open Traceroute→ History opens saved results. Select “Run again” to start a new test.
Compare DNS records, resolvers and response times across locations.
Open DNS→ History opens saved results. Select “Run again” to start a new test.
Combine route tracing with repeated probes to inspect hop latency and loss. Intermediate hop rate limiting does not establish destination packet loss.
Open MTR→ History opens saved results. Select “Run again” to start a new test.
Inspect HTTP status, response headers and request timings from different locations.
Open HTTP→ History opens saved results. Select “Run again” to start a new test.